070113®Setup Guide
Reef Crest Random Mode simulates a high-energy reef environment. It is indicated by both a yellow control dial and the first two blue LEDs illuminat
1918WarrantyEcoTech Marine warrants to the original purchaser only that the VorTech Propeller Pump will be free from defects in material and workmansh
2120Regulatory Information• This product carries an ingress protection rating of IPX0 and must not be immersed in water.• Danger: To avoid possible e
Customer Support ... 1Inside the Box ... 2Maintenance ... 3Installing the VorT
2 3Inside the BoxPOWER SUPPLY POWER CORD FOAM GUARDMOUNTING TABS (X4)DRIVERVELCRO STRIPS (X2)DRY SIDEZIP TIES (X4)WET SIDEYour VorTech Propeller Pump
Installing the VorTech™STEP 1: Choose Pump Location• Where the pump output is unobstructed• High enough above the sand bed so sand is not disturbed• S
STEP 6: Attach Wet Side• Place the wet side into the aquarium and allow ALL air to escape from the propeller housing.• Carefully align the wet and d
8The EcoSmartTM Driver Mounting the DriverSET ButtonMODE ButtonWireless IndicatorLED StripOPTION/Power ButtonBattery Backup InputPump Cable SlotPower
EcoSmar tTM Driver Operational Modes10 11* LED bar will indicate change between modes.(Hold) – Feed Mode (Hold) – Power Off
Side Opposite MasterSame Side as MasterBack of AquariumNutrient Transport Mode (NTM) creates circulation in a two-phase program. The first phase uses
14 15 AUTO TUNE Auto Tune allows you to create a wave within your tank. To create a wave using Auto Tune, Hold SET and OPTION until LEDs move back a
Kommentare zu diesen Handbüchern